HEY FRIENDS! Today I have another project featuring the Anita Jeram Just Add Snow stamp set, part of the new release by Colorado Craft Company. I love the Anita Jeram bunnies (and mice and cats!) so I knew that I would have to color up this image. As always, I’ve linked supplies with compensated affiliate links used where possible at no cost to you.
Featured Supplies
COPICS: R20, W1, W3, W5 (rabbit); BV0000, BG0000, BG10 (snowman)
[Compensated affiliate links used when possible. In addition, as an Amazon Associate I earn from qualifying purchases. Items marked with an asterisk (*) were provided by a store or the manufacturer. All other items were personally purchased.]
* Anita Jeram Just Add Snow | Colorado Craft Company
[ 3C ]
Anita Jeram Kittens & Mittens | Colorado Craft Company
[ 3C ]
Copic Markers
[ BLICK ]
Memento Tuxedo Black | Tsukineko
[ SSS ]
Nesting Rectangle Infinity Dies | Hero Arts
[ SBC ]
Mint Low Tack Tape | Scrapbook.com
[ SBC ]
Mint Low Tack Tape – 4 inch roll | Scrapbook.com
[ SBC ]
Ink Blending Tool with Domed Foam Applicators
[ SBC ]
Solar White Cardstock | Neenah
[ AZ ]
Step by Step Instructions
- Cut card base from Neenah Classic Crest 110# cardstock to 4.25″ x 11″ and score at 5.5″ for a top fold card.
- Cut a piece of Hammermill cardstock to 4.25″ x 5.5″ and mask the top and sides at 0.75″ using Mint Tape (1 inch tape).
- Stamp the image from the Anita Jeram Just Add Snow stamp set as shown using a Copic compatible ink (I used Memento in Tuxedo Black).
- Stamp the image on a piece of Mint Tape (4 inch tape) or other masking paper. Fussy cut the image and mask the stamped image on the panel.
- Mask the bottom panel below the stamped image to create a rectangle. At this point, the only exposed area is around the stamped image. See image for reference.
- Ink blend the area around the image using Distress Ink in Salvaged Patina. I do this as a bse layer because it’s easier to ink blend multiple colors on top of ink instead of dry paper.
- Starting at the top, ink blend from top to bottom using Distress Ink in Uncharted Mariner, Mermaid Lagoon, and Salvaged Patina.
- Remove the masking over the stamped image and color with Copic markers (see marker list below).
- Select the snow image from the Kittens and Mittens stamp set and position across the top of the image area. Stamp with Versamark Ink, cover with white embossing powder, and heat set.
- Remove all the masking.
- Stamp the sentiment using Versafine Clair in Nocturne.
- Trim the panel using the Nesting Rectangle Infinity Dies from Hero Arts.
- Assemble layers as shown.
Hope you enjoyed today’s project! See you again soon!
